How do you get mold out of a motorcycle helmet? - hjc cs
I've got my motorcycle helmet for the winter and when I was mold in the filling. I have an HJC CS-12 helmet.
Saturday, January 9, 2010
Hjc Cs How Do You Get Mold Out Of A Motorcycle Helmet?
7 comments:
take a small amount of bleach (two fulls CAP) and the mixture into a glass of water, DAB, and then in the fields of tool. If you can not kill mold. Then put the helmet on the outside to dry in the sun, or sit on the plate heat of the hot, dry air will blow on ... or you can also use a hair dryer on low.
You can get if the laundered to fill, if not then a bit of detergent and hand wash using and drain well let it dry completely before you
Lysol form.
Febreze or similar to the smell.
$ 75.00 for a new one.
Next year, no boxes, so that a shelf where you can get the air circulation.
Lysol form.
Febreze or similar to the smell.
$ 75.00 for a new one.
Next year, no boxes, so that a shelf where you can get the air circulation.
I have an HJC helmet, too! I use to race. Sounds like a stinky situation. Sunshine is the only thing I would do, and then clean the interior with fabreeze Fabric Refresher. Then go ahead and buy another interview that old forms Spair.
Bleach Mold can be removed, but then filling melted, etc. Try contacting the manufacturer to see if you can buy for the stuffing inside the shell. Good luck!
It would be less worried about the cast and more concerned about damage to its EPS (extruded polystyrene) liner may have suffered have been exposed to prolonged moisture.
This foam polystyrene material, the inside of his shell and is an essential part of the capacity of their helmets in an accident.
Get a new helmet.
Post a Comment